南海北部神狐海域细粒储层矿物组分对天然气水合物储集赋存的影响     

徐小蕾  白辰阳  苏丕波  马倩  张宇  梁金强 《地质论评》2023,69(6):2023060012-2023060012

为了探明矿物类型对于天然气水合物成藏的影响,笔者等利用南海北部神狐海域W07站位样品及其水合物饱和度数据,进行XRD全岩和黏土矿物测试分析、比表面积分析以及束缚水能力综合分析。结果表明,海床下110~127 m（即110~127 mbsf,meters below sea floor, 海床以下深度）为水合物储层段,海床下127~156 m为非水合物储层段。通过XRD分析可知,高石英及长石含量,低伊蒙混层含量的层段,比表面积与束缚水能力较低,说明其具有相对较好的孔渗条件,为水合物的运移与储集提供了良好的空间条件,因此形成水合物储层段;而在高伊蒙混层的层段中,比表面积较大,束缚水能力较强,其对甲烷气体及流体的吸附和束缚能力较强,对水合物成藏起到潜在的封隔作用,成为非储层段,储层与非储层段纵向叠置序列有利于优质水合物储层的形成。本次研究总结了矿物组分与优质水合物储层之间的关系,并揭示两者存在的潜在成因联系,以期丰富水合物富集成藏的基础理论,对未来南海北部天然气水合物的商业化开发提供支持。  相似文献   

昆明呈贡石灰岩上覆红黏土干缩裂隙的温度效应     

何岱洵 《地质与勘探》2023,59(5):1083-1092

温度是影响土体干缩开裂的重要外部环境因素之一。为研究温度对红黏土干缩裂隙的影响,以昆明呈贡石灰岩上覆红黏土为对象,经风干、碾碎和筛分后,选取2 mm以下的细颗粒,用正方形钢化玻璃容器制备9个厚度为10 mm的饱和泥浆样,分成3组,每组3个平行样,利用控温烘箱分别进行30℃、50℃和70℃的干燥试验,试验过程中定时称重试样和对土样表面进行拍照,然后用PCAS软件对照片进行图像处理。结果表明：红黏土的蒸发过程可分为3个阶段,干缩裂隙的形成和发展可分为5个阶段;温度升高,干燥完成时间减短,常速率阶段的蒸发速率和蒸发量增大,最终含水率降低;初始临界含水率随温度升高而增大;随着土体含水率持续减小,表面裂隙率先缓慢增加,然后快速增大,最后趋于稳定;温度升高,裂隙交点数、裂隙条数、裂隙总长度和土块数减少,裂隙平均长度、裂隙平均宽度、表面裂隙率、土块平均面积、土块最大面积、干缩厚度和干密度增大。温度显著影响红黏土的水分蒸发过程,干缩裂隙的形成和发展,以及表面裂隙结构和形态。  相似文献   

考虑桩体刺入变形的透水混凝土桩复合地基固结理论研究     

韩柏林卢萌盟 《岩土力学》2023,(8):2360-2368

现有的多元复合地基利用两种或者两种以上的桩型对地基土进行加固,以期提高地基承载力、加速地基固结。提出了一种兼具散体材料桩和刚性不排水桩自身优点的透水混凝土桩复合地基固结模型。工程中刚性桩与土体的压缩量并不相等,这与等应变条件存在着不一致的地方。为此,抛弃传统等应变假设,考虑桩体向垫层和下卧层的刺入变形,对传统等应变假定进行修正,同时考虑了扰动区土体水平渗透系数的抛物线变化和水在桩体内的径向、竖向渗流,给出了此类固结问题的控制方程和解答以及复合地基固结度的表达式,并对复合地基固结度的解进行了讨论。最后与其他复合地基解做了比较并对固结性状进行了分析,并针对透水混凝土桩孔隙引起的桩阻作用对地基固结速度的影响进行了验证。  相似文献   

松辽盆地古龙凹陷页岩油储层中的纳孔纳缝及其原位成藏理论初探     

何文渊 《地学前缘》2023,30(1):260-280

古龙凹陷青山口组页岩油的,地质资源量达151亿t,是重要后备的油气资源。用电子背散射(HDBSD)发现了古龙页岩油储层中纳米孔和纳米缝非常发育,电子探针表明这些纳孔纳缝均被沥青充填。纳米孔的直径多在10～50 nm,中位数在20～30 nm,形态多不规则,多呈多角形,主要是一种E-F纳孔,其次为E-E纳孔,多与纳米缝联结。纳缝宽度多在10～50 nm,中位数也在20～30 nm。它们主要是由黏土片(黏土域)的F-F凝聚形成的。黏土的凝聚与有机质密切相关。黏土胶体由于同晶置换会带负电荷,使得其周围会吸附带正电的金属阳离子,形成一个带正电的黏土团。这种带正电的黏土团又会吸附带负电的腐殖酸(有机质)和初步降解的藻,形成一个有机黏土絮凝体。这种有机黏土絮凝体进入生排烃门限后,由于生排烃有机质体积会收缩,体积收缩最高可达87%。生排出的烃会就近充填在这种收缩形成的孔隙中,又由于纳孔纳缝的毛细阻力(约12 MPa)等使得排出的烃无法运移出去便形成了古龙页岩油的特殊连续原位油藏。  相似文献   

大尺度平原城市精细汇水区分级划分研究     

王岩  范子贤  李成名  戴昭鑫  吴政 《测绘通报》2021,(7):117-120,125

在城市内涝模拟研究中,汇水区划分是十分重要的环节,同时对大尺度平原城市进行汇水区精细划分也是研究者共同研究的技术难点。针对现有基于DEM流向分析的划分方法存在的无法正确反映实际城市复杂地形和流向问题,本文提出了一种顾及地类和流向,适用于大尺度平原城市的精细汇水区分级划分方法。首先,从城市自然地形和主干河流出发,进行一级宏观尺度划分;然后,依据城市主次干道,干渠和管网实现二级中观尺度划分;最后,在二级划分的基础上,结合流向和地类做精细的三级子汇水区微观尺度划分。本文选取东营市30 km²核心主城区进行了验证分析,研究结果表明,划分结果跟实际地物类型和真实流向相吻合,该方法对于大尺度平原城市具有良好的适用性。  相似文献   

海洋沉积物黏土矿物相对含量不同计算方法对比研究     

舒雨婷  刘志杰  余佳  孔敏  田先德  刘升发 《海洋通报》2019,(5):585-590

海洋沉积物黏土矿物相对含量计算存在多种计算方法,并不统一,限制了异源黏土矿物的整合和使用。文章选取了两种较为常见的计算方法,即Biscaye和国标中规定的计算方法,分别对东印度洋109个表层样品黏土矿物的相对百分含量进行计算,分析对比了两种方法计算结果之间的差异。结果显示,两种计算方法结果存在显著正相关,都能显示黏土矿物分布的变化趋势,4种黏土矿物相关系数由高到底分别为:蒙皂石0.986、伊利石0.974、绿泥石0.924、高岭石0.923。相对于Biscaye计算方法,国标计算方法会增加伊利石和高岭石的相对百分含量而降低蒙皂石和绿泥石的相对百分含量。两种计算方法黏土矿物的含量相关性较好,可以建立起相互数学转换关系式。但在不同的海区,由于矿物成因、结晶程度以及混层矿物的出现可能会使衍射峰形态发生改变,从而相关性系数和转换关系也会相应发生改变。  相似文献   

Hypoplastic interface models for fine‐grained soils          下载免费PDF全文

Henning Stutz  David  Mašín 《国际地质力学数值与分析法杂志》2017,41(2):284-303

  相似文献   

Numerical modeling and neural networks to identify model parameters from piezocone tests: I. FEM analysis of penetration in two‐phase continuum     

Rafał F. Obrzud  Andrzej Truty  Laurent Vulliet 《国际地质力学数值与分析法杂志》2011,35(16):1703-1730

  相似文献   

Diffusive mass exchange of non‐reactive substances in dual‐porosity porous systems – column experiments under saturated conditions          下载免费PDF全文

Bastian Knorr  Piotr Maloszewski  Florian Krämer  Christine Stumpp 《水文研究》2016,30(6):914-926

Diffusive mass exchange into immobile water regions within heterogeneous porous aquifers influences the fate of solutes. The percentage of immobile water is often unidentified in natural aquifers though. Hence, the mathematical prediction of solute transport in such heterogeneous aquifers remains challenging. The objective of this study was to find a simple analytical model approach that allows quantifying properties of mobile and immobile water regions and the portion of immobile water in a porous system. Therefore, the Single Fissure Dispersion Model (SFDM), which takes into account diffusive mass exchange between mobile and immobile water zones, was applied to model transport in well‐defined saturated dual‐porosity column experiments. Direct and indirect model validation was performed by running experiments at different flow velocities and using conservative tracer with different molecular diffusion coefficients. In another column setup, immobile water regions were randomly distributed to test the model applicability and to determine the portion of immobile water. In all setups, the tracer concentration curves showed differences in normalized maximum peak concentration, tailing and mass recovery according to their diffusion coefficients. These findings were more pronounced at lower flow rates (larger flow times) indicating the dependency of diffusive mass exchange into immobile water regions on tracers' molecular diffusion coefficients. The SFDM simulated all data with high model efficiency. Successful model validation supported the physical meaning of fitted model parameters. This study showed that the SFDM, developed for fissured aquifers, is applicable in porous media and can be used to determine porosity and volume of regions with immobile water. Copyright © 2015 John Wiley & Sons, Ltd.  相似文献   

Dynamic analysis of strain localization in water‐saturated clay using a cyclic elasto‐viscoplastic model     

B. Shahbodagh Khan  M. Mirjalili  S. Kimoto  F. Oka 《国际地质力学数值与分析法杂志》2014,38(8):771-793

A computational framework is presented for dynamic strain localization and deformation analyses of water‐saturated clay by using a cyclic elasto‐viscoplastic constitutive model. In the model, the nonlinear kinematic hardening rule and softening due to the structural degradation of soil particles are considered. In order to appropriately simulate the large deformation phenomenon in strain localization analysis, the dynamic finite element formulation for a two‐phase mixture is derived in the updated Lagrangian framework. The shear band development is shown through the distributions of viscoplastic shear strain, the axial strain, the mean effective stress, and the pore water pressure in a normally consolidated clay specimen. From the local stress–strain relations, more brittleness is found inside the shear bands than outside of them. The effects of partially drained conditions and mesh‐size dependency on the shear banding are also investigated. The effect of a partially drained boundary is found to be insignificant on the dynamic shear band propagation because of the rapid rate of applied loading and low permeability of the clay. Using the finer mesh results in slightly narrower shear bands; nonetheless, the results manifest convergency through the mesh refinement in terms of the overall shape of shear banding and stress–strain relations. Copyright © 2013 John Wiley & Sons, Ltd.  相似文献